top of page
Search

Floor finishes over underfloor heating: tiles, stone, wood and carpet

Writer: Szymon Wielinski
Szymon Wielinski
Nov 14
2 min read

Almost any floor can go over underfloor heating, but the finish changes how much heat comes through and how warm the floor is allowed to get. Choose the finish before the heating is designed, because it affects the pipe spacing and the water temperature.

How the finish affects heat output

As a rule of thumb, a heated floor gives out about 10 watts per square metre for every 1°C that its surface is warmer than the room. A finish that insulates the floor, or that limits how warm the surface can get, therefore limits the heat the room receives.

Tiles and stone

Porcelain, ceramic and natural stone conduct heat well, so the floor warms up quickly and evenly. They are the most efficient finish over underfloor heating, and the natural choice in bathrooms and kitchens. Use a flexible tile adhesive and leave movement joints so the floor can expand and contract as it heats and cools. With natural stone, a floor probe keeps the surface within the manufacturer's limits.

Engineered wood and timber

Many timber flooring manufacturers set a maximum surface temperature of 27°C. In a room at 20°C that limits the heat output to about 75 watts per square metre, so the room's heat loss needs checking at the design stage. Follow the flooring manufacturer's instructions on moisture, underlay and how the floor is brought up to temperature for the first time.

Vinyl, LVT and laminate

These work over underfloor heating if the product is approved for it. Vinyl and linoleum need an adhesive suitable for heated floors, and the surface must stay below the temperature the manufacturer specifies.

Carpet

Carpet and underlay insulate the floor, so the combined tog value matters. BS EN 1264 has long been read as advising a maximum of 1.5 tog for floor coverings, but tests by the Underfloor Heating Manufacturers Association at BSRIA found that carpet and underlay up to 2.5 tog can be used over wet underfloor heating without impairing its efficiency. Electric systems are stricter, and some manufacturers set 1.5 tog as the limit. Choose an underlay made for underfloor heating, and check the figure with the heating manufacturer before you order.

Before you choose

  • Tell your installer the finish for each room before the heating is designed.

  • Allow drying time for a new screed before tiles or timber go down.

  • Set floor probe limits for stone, timber and vinyl.

Read how underfloor heating changes comfort at home and why it suits a heat pump. Koniu Construction plans, fits and finishes underfloor heating in Walton-on-Thames, Hersham, Cobham and Stoke d'Abernon. See our underfloor heating service or book a survey visit (£150).

 
 
 

Comments


Bathroom renovations, garden design and landscaping in Walton-on-Thames, Hersham, Whiteley Village, Burwood Park, Cobham, Stoke d'Abernon and Downside (KT12 and KT11).

© 2026 Koniu Construction Ltd. Registered in England and Wales, company number 11968442. Registered office: 4 Gables Court, 239-241 Malden Road, London SM3 8EQ.

Privacy policy  |  Terms and conditions  |  Cookie policy  |  Complaints procedure  |  Health and safety policy  |  Environmental policy  |  Find us on Houzz

® © ™
  • KoniuConstruction
  • KoniuConstruction
  • KoniuConstruction
  • KoniuConstruction
bottom of page