Why the floor matters more than the tiles: strengthening a bathroom floor

When people plan a bathroom, they think about tiles, brassware and the bath. The part that decides whether the room still looks right in ten years is the floor underneath. Tiles and grout are rigid. A timber floor bends a little every time someone walks across it. If the floor moves more than the tiles can tolerate, something has to give.
Why timber floors flex
Most upstairs bathrooms in Walton-on-Thames, Hersham and Cobham sit on timber joists with floorboards or chipboard on top. Several things make them move:
Joist size. LABC Warranty's technical guidance on tiling timber floors notes that older properties tend to have shallower joists than current standards require for the same span.
Notches and holes. Over the years, pipes and cables are often run through cuts in the joists, which weakens them.
Old boards. Floorboards and chipboard loosen with age, and chipboard loses strength if it has ever been wet.
Earlier leaks. A joist end that has been damp for years may have started to rot. Read how hidden bathroom leaks damage the structure.
How much weight a bathroom adds
A litre of water weighs a kilogram, so a bath holding 200 litres adds 200 kg of water before the weight of the bath and the person in it. A cast iron or stone resin bath can add well over 100 kg more. Natural stone tiles and a screed for underfloor heating add weight across the whole floor. Much of the load sits on a small area between two or three joists.
What movement does
Grout cracks, often in a straight line along a joist.
Tiles come loose or crack. Large-format tiles are more likely to crack because each one spans more of the movement.
The silicone seal round the bath or shower tray tears, and water gets behind it.
Once water gets in, the boards and joists below get wet and weaker, and the movement gets worse.
How a bathroom floor should be prepared
LABC Warranty's guidance for tiling on timber floors with joists at up to 600 mm centres is either 18 mm exterior-grade plywood screwed to the joists at 300 mm centres, with every edge supported and a small movement gap between sheets, or moisture-resistant decking overlaid with at least 10 mm of exterior-grade plywood. Where the floor would still deflect too much, the guidance is to strengthen or replace the joists to a structural engineer's design.
In practice, preparing a timber bathroom floor usually means:
Lifting the old boards so the joists can be inspected.
Cutting out and replacing rotten or badly notched sections.
Strengthening the joists by fixing new timbers alongside them (sistering) and adding solid blocking between them, so the floor works as one.
Screwing down plywood at close centres, then a tile backer board or decoupling membrane.
Tanking the wet areas and laying the tiles in a flexible adhesive.
A wet room also needs a floor built to a fall towards the drain without flexing. Our guide to wet rooms and walk-in showers covers this.
A simple check you can do
Stand where the bath or shower is and rock gently from heel to toe. If you can feel or hear the floor move, or a glass of water on the floor ripples when someone walks past, the floor needs attention before new tiles go down. Creaking boards, a dip near the bath and grout cracked along one line are other signs.
What it costs compared with a leak
In our bathroom cost calculator, the plywood for a typical 6 m² family bathroom floor comes to about £330, and strengthening the joists to about £1,260. Aviva's 2026 figures put the average escape of water claim at £8,595. The floor is one of the smallest lines in a bathroom budget and one of the most important.
Plan your bathroom with Koniu
Koniu Construction designs and builds bathrooms in Walton-on-Thames, Hersham, Burwood Park, Cobham and Stoke d'Abernon. At the survey visit (£150) we look at the floor as well as the room, and the written quote includes any work it needs. Call 07434 781033 or contact us.





Comments